Dual O2 wire connections

Forum for discussing how to install MicroSquirt(TM), choose and troubleshoot sensors, wiring, and communications for MicroSquirt (TM) and MicroSquirt Module(TM).
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
RojoScarp
MegaSquirt Newbie
Posts: 3
Joined: Sat May 13, 2006 3:02 pm
Location: North Texas
Contact:
Contact RojoScarp

Dual O2 wire connections

Post by RojoScarp »

I've been gone for a year due to illness, but am back and needing to refresh memory. I posted "I have modified my PCB as per instructions for dual wide band O2's. I have two widebandO2's in my car." last year. Where did I find to instructions to do this? Assuming I did it correct. My O2's are both LC-1 controlled. To wire to MSII & relay board, one goes to #20 on relay, where does the second connect? Somewhere in the harness I remember, was it #27. Thanks Rojo
Top
molybdanum
MegaSquirt Newbie
Posts: 2
Joined: Wed Aug 20, 2008 12:49 pm

Re: Dual O2 wire connections

Post by molybdanum »

I am interested in this also.
Top
Post Reply

Return to “Installation, Wiring and Sensors”