Has anyone tried using epoxy mount aluminum injector bungs in a cast iron manifold.
I am concerned that the difference in expansion between the two materials may cause the epoxy to fail.
I have searched around for steel bungs thinking I could braze them in but no luck so far.
Neal
newbie first question
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
newbie first question
Has anyone tried using epoxy mount aluminum injector bungs in a cast iron manifold. I am concerned that the difference in expansion between the two materials may cause the epoxy to fail. I have searched around for steel bungs thinking I could braze them in but no luck so far. Neal
-------------------- m2f -------------------- This post is at: http://www.msefi.com/viewtopic.php?p=135553#135553 -------------------- m2f --------------------
Posted by email.
-------------------- m2f -------------------- This post is at: http://www.msefi.com/viewtopic.php?p=135553#135553 -------------------- m2f --------------------
Posted by email.