ok im new to megasquirt and i have a MS II 3.0 with a inovatiove lc-1 wide band.
now when im in mega tune on the screen with all the guages my AF gauge is stuck at 11.9. but when i go in to my AF table that large gauge is stuck there to but the spot below the map is reading right i think cuz it moves around where i want it to go for the AFR.
anyone have any ideas whats wrong?
weird problem with air fuel gauge
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bernard Fife
- Super Squirter
- Posts: 1009
- Joined: Mon Feb 16, 2004 3:15 pm
orange88,
When you set up MegaTune, did you use mtCfg.exe to select the LC-1? (http://www.megamanual.com/megatune.htm#installprocess)
Then when in MegaTune, did you calibrate the AFR table to the LC-1? (http://www.megamanual.com/megatune.htm#oa)
Those are the two most likely problems (assuming you activated the corrct INI file for your code).
Lance.
When you set up MegaTune, did you use mtCfg.exe to select the LC-1? (http://www.megamanual.com/megatune.htm#installprocess)
Then when in MegaTune, did you calibrate the AFR table to the LC-1? (http://www.megamanual.com/megatune.htm#oa)
Those are the two most likely problems (assuming you activated the corrct INI file for your code).
Lance.