Innovate LC1 setup

jonfx4com · Post by **jonfx4com** » Thu Jun 15, 2006 12:39 pm

Hope someone can help.

I have an innovate LC1 wideband. When I go to calibrate afr table in MEgatune (MS2 2.672) I can select innovate wb 0-5 V but how do I know how to calibrate the LC1 in the LC1 programmer application since I don't see anywhere in megatune that tells me what afr it is expecting at 0v and what afr it is expecting at 5V.

Regards

Jon

tmbg · Post by **tmbg** » Thu Jun 15, 2006 12:45 pm

Mine came with one output set to 0-5V already, I believe it's 10:1 at 0V and 20:1 at 5V

jonfx4com · Post by **jonfx4com** » Thu Jun 15, 2006 1:03 pm

Thanks,

I found just some stuff on innovates site:

"The LC-1's analog output 2 is factory programmed to provide a
linear output between 0V and 5V for an AFR of 7.35 to 22.39. Any other linear output range
between 0 and 5V can be programmed. See chapter 6.5: Programming the analog outputs for
details."

but does MS2 assume the LC1 is at its default settings?
Jon

tmbg · Post by **tmbg** » Thu Jun 15, 2006 2:06 pm

I believe so!

cossie_storm · Post by **cossie_storm** » Fri Jun 16, 2006 2:11 am

hi
if you chose the rigth wide band in mtcfg, and adjust lc-1 in the sw that comes with it to the rigth value, you should be god to go