escort timing

MSBoostedEscort · Post by **MSBoostedEscort** » Fri May 12, 2006 4:48 pm

ive read the sticky about 3 tmies, ive used 4 different maps, came up with a few of my own, but im still not satisfied that thats good enuf. it still feels like its holding back.

i think one of my problems is the trigger angle.. the actual sensor and missing tooth is roughly 45* from TDC, but from all the maps ive used and have been given they all have a 60-80* trigger angle in spark settings...
can someone plz explain how to obtain the proper angle.

Bernard Fife · Post by **Bernard Fife** » Sat May 13, 2006 6:49 am

can someone plz explain how to obtain the proper angle.

MSBoostedEscort,

For MS-II, see this: http://www.megamanual.com/megatune.htm#og

If you have something else, you'll have to let us know what it is...

Lance.

MSBoostedEscort · Post by **MSBoostedEscort** » Sat May 13, 2006 8:35 pm

im using ms1 2.2 .024Extra, no relay board, EDIS 4 36-1 tooth wheel. the actual sensor is mounted roughly 45* angle....

however, when i had the head off, at TDC, the missing tooth was perfectly even with the VR sensor. so i started with a 0* angle and had decent results, however alot of other ppl i have talked to and some research i have done sugest 72*,68*,45*, some other random numbers.

Bernard Fife · Post by **Bernard Fife** » Sat May 13, 2006 9:07 pm

MSBoostedEscort,

You should use the value recommended in the MS1/Extra docs here: http://megasquirt.sourceforge.net/extra/setup.html and here: http://megasquirt.sourceforge.net/extra ... dware.html

Lance.

MSBoostedEscort · Post by **MSBoostedEscort** » Sun May 14, 2006 1:11 pm

lance, i looked over that many times... however those angles do not pretain to my setup.

it says that it should be 90* or roughly 9 teeth... however, my car came stock with EDIS 4 and it only has 3 teeth space between TDC and the missing tooth... i took some pictures.

here you can see the crank is exactly at TDC and the missing tooth is 3 teeth ahead.... not 90*

here you can see the mounted position of the stock VR sensor.

here i have marked the position of TDC in relation to the missing tooth

so what i have came up with is this...... judging from these pictures i think the trigger angle should be roughly 30*. what do you think?

MSBoostedEscort · Post by **MSBoostedEscort** » Sun May 14, 2006 3:38 pm

so i set the angle at 30* and it runs great.