Using LED17 as spark output and bosch idle valve??
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
bertelli_1
- MegaSquirt Newbie
- Posts: 11
- Joined: Sat Jan 14, 2006 1:29 am
- Location: Milton Keynes, UK
Using LED17 as spark output and bosch idle valve??
I'm looking to use the bosch idle air control valve on my Mk2 Golf and use LED17 as the spark output. From what I understand I need to change Q4, remove Q20 and D8 and jumper R39. Put a 1N4001 diode across the idle valve. To change the spark output I need to run a wire from D20 to LED17 (with inline resistor) and from there to X11. Is this right? I'm running MSNSextra on a V3 board.