Typo In The Mega Manual??

For discussing MicroSquirt (TM) configuration and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
69 1/2 Six Pack Bee
Helpful Squirter
Posts: 74
Joined: Fri Aug 20, 2004 10:12 am
Location: Ontario, CA

Typo In The Mega Manual??

Post by 69 1/2 Six Pack Bee »

In the Setting the Acceleration Enrichments section in the tuning instructions it states:
After you have the VE table dialed in, then start adjusting the acceleration enrichment. You may want to try a short acceleration shot time (like 0.2 ms) and increase the accel enrichment bins...
Yet, I am a little puzzled as the only thing I can see that this refers to is the "Accel time" and this value is expressd in seconds and not milliseconds.
Should the above be changed to : "try a short acceleration shot time (like 0.2 secs)..." ???
Thanx,
Bud
Bernard Fife
Super Squirter
Posts: 1009
Joined: Mon Feb 16, 2004 3:15 pm

Post by Bernard Fife »

Bud,

Yes, you are right, I will fix it right now.

Lance.
69 1/2 Six Pack Bee
Helpful Squirter
Posts: 74
Joined: Fri Aug 20, 2004 10:12 am
Location: Ontario, CA

Post by 69 1/2 Six Pack Bee »

Phew...!
Thank goodness. For a minute I thought I was having eye problems too :(
I remember setting up the MS-I in milliseconds and I was hoping this was the same. At least we made the correction for the benefit of the noobs..and admittedly, myself as well.

Thanx, Lance!
Post Reply