going back to MS1?

proboner · Post by **proboner** » Sat Mar 25, 2006 4:15 pm

version 2.2 board
megasquirt 2
megatune 2.25

so i was running MS1 for simple fuel control and converted to MS2. i temporarily want to run MSnS-e which means converting back to the MS1 processor. what steps do i have to take to go back? i tried to simply swap the processors but that didnt work.

Mike_Robert · Post by **Mike_Robert** » Sat Mar 25, 2006 4:40 pm

The swap should have worked without a problem. What changes might you have made to the board when you switched to MSII?

-Mike

Bernard Fife · Post by **Bernard Fife** » Sat Mar 25, 2006 5:13 pm

proboner,

You have to remove the 12V supply to the 40-pin socket if you installed it, and you need to use mtCfg.exe to activate the appropriate INI file for your new code, as well as setting the CODE_VARIANT.

Lance.