MicroSquirt.com read only forum (Jan.15,2018)

I just switch from narrow band to a LC1 Wideband. I went under setting and "set the innovate 0-5v". I am confused exactly what each of the setting do under exhaust gas settings.
Is the switch point the point for 14.7/1 stoich?
controller authority?
How do i get my 02 gauge in Megatune to read ...

Yeah, got it working. Now i have crazy RPM reading.

new info above.

I have megasquirt1 w/ V2.2 w/edis, which megatune should i use. Everytime i open mine, it says , incorrect compatiblity, table corruption may occure.

I downloaded the firmware. But no matter which file i set (either MS1, Msnedis, MSNextra) Megatune says it is receiving "" from the controller ...

I am still new to all of this. But this is what i got. MS1 with EDIS on a version 2.2 board. My engine a 20v 4age Supercharged. I got the engine running pretty good and close. The car really pulls down low but power seems to run out early! Its on a race car that is not steet legal so its not so easy ...

as hommer would say DOPE. thanks guys. Any place you can help me to start with ignition? thanks


Scott

I use Marc's MAP from the black top i just retarded the timing slightly. It's online here somewhere. How much manifold pressure should i expect with 7 psi? thanks

Scott

I have had the megasquirt on my silvertop 20v for a couple of months. Its been good me. I have just fitted the GZE supercharger to the 20v and 4 thortles so i was wondering if anybody had some base maps to start with. I will be honest, i am alot better with fabrication then tuning. I am going to be ...