MicroSquirt.com read only forum (Jan.15,2018)

My Problem must have been a bad connection. I rewired it and everything is normal. But i have an another problem. I am not gettig tach signal. I replaced the R10 with a 1/2watt 1k resistor, and that did not solve the problem. Any ideas what i check next?

I got my MS hooked up again..... Everything checks out fine but, my TPS signal is real retarded. I go into the "real Time Display" , hit the pedal (car doesn't run yet) and it is sluggish like would take 5 full seconds to match my foot.....like if i floored it would = 100%.

So what causes that? :?

I am trying to upgrade from regular code to 029f.
Back ground, ECU=v2.2 , i don't have a stim I am trying to run Megatune 2.25 I then downloaded firmware 029f, and tried the boot jumper, and download step.. It always says failed expected response " then it says recieved "". So if i have something ...

Cool so i thouht that my engine ran a little different because of this. But our right the required fuel never changes!!

Yo, i have not ran with the 029 code yet. But i hope to be within a wk. Also i have been having problems with my "REQ Fuel" Cubic inchs, or in yor case CC's. It always resets to 350 cui, and my lbs per hour always resets to 42 lbsers. So if no-one can figure this out i bet i can tune with it like ...

I did have that problem the first time, with low voltage. I am just creating the MSQ. file for me to use in a month or so, the MS is not even hooked up to the pc im using. How do i use the mtCfg.exe to activate the right ini file? I am pretty sure i just went into the "settings" file and set msns ...

ok so i have recently upgraded to 029 code , and every time i Reset Mtune it resets my engine size, and inj size?? "huh"? how can i get this to stop?

As far as Mstweak. First make sure that you have the most up to date version. Then go into the settings in MStweak, then set your "Ego crossover to 2.5 volts". Also you will need to find where your Megatune is installed (which directory on the pc) find a file called "car 1" go into there and find a ...