MicroSquirt.com read only forum (Jan.15,2018)

i made a spreadsheet that did this as a bit of a curiosity, it allowed me to compare power runs. however it didnt have much resultion so you had to perform about 4-5 runs wiht hte same settings before changeing somehthing and running agin. and even then even undulations in the road affected the ...

Ok, that sounds good... But how do you control the warm-up thingie? It has no cables going to it, just two hoses and that's it.
BTW, there's an idle adjustment screw also,

i know nothign about this setup, but i'd hazard a guess engine coolant just goes through the hoses and the valve thing is ...

check the voltage at the megasqurt , make sure your not getting any unwanted volt drops due to a bad connectio or earth strap, and keep playing with the warmup bins..youll get there eventually.

little q, what size of resistor should i be useing? .. cheers. just installed an LC-1 but not hooked up to megasquirt yet. just got it emulating a narrowband for now.