Straight from Jerry at diy
First off, you want to have the LC-1 sharing the ground with your MegaSquirt. Also you should use a 470 ohm resistor in between the analog output of the LC-1 and the o2 input of the MS.
Then you need to configure:
In the MegaTune Configurator:
# set INNOVATE_0_5_LINEAR ...
Search found 3 matches
- Thu May 04, 2006 8:34 am
- Forum: Tuning Fuel and Air
- Topic: Quick WB O2 Question ?
- Replies: 11
- Views: 1181
- Wed May 03, 2006 8:43 am
- Forum: Tuning Fuel and Air
- Topic: Quick WB O2 Question ?
- Replies: 11
- Views: 1181
The stock form was not 0-5v 10-20 AFR. I got it set up though. It is just unclear in Megatune what the "calibrate O2 sensor" is looking for. The Innovate is labeled "Innovate 0-5." So I guess 0-5v 10-20 AFR. I always though there was a separate calibration to use it in stock form but I guess not ...
- Mon May 01, 2006 12:21 pm
- Forum: Tuning Fuel and Air
- Topic: Quick WB O2 Question ?
- Replies: 11
- Views: 1181
Ok, I'm going from the top of my head on this one, since it's been about 9 months since I switched to my LC1 WBO2.
Ok, with you Innovative sensor and controler, it comes with directions. Read them a little after I tell you this. Just to make sure I'm correct.
Ok first, I am guessing you calibrated ...
Ok, with you Innovative sensor and controler, it comes with directions. Read them a little after I tell you this. Just to make sure I'm correct.
Ok first, I am guessing you calibrated ...