Thank you - new FTDI cable worked a treat.
I'm a complete novice at this and so would appreciate your thoughts. We have a Ford 302 racing engine, which is supercharged. It's running rich - the air fuel ratio is ~10. How do I change this using TunerStudio? Is there a good place for a novice to ...
Search found 3 matches
- Wed Sep 06, 2017 7:06 am
- Forum: Tuning Software
- Topic: Connecting MS V3 to TunerStudio MS?!
- Replies: 5
- Views: 3065
- Fri Sep 01, 2017 10:38 pm
- Forum: Tuning Software
- Topic: Connecting MS V3 to TunerStudio MS?!
- Replies: 5
- Views: 3065
Re: Connecting MS V3 to TunerStudio MS?!
Thanks for the response, really appreciated.
The drivers seemed fine and I was using the right baud rate.
I'm unsure of the chip in the cable. It was this one from Amazon. Is it most likely the cable? I'll order an FTDI compatible one.
RELPER USB 2.0 to Serial (9-Pin) DB-9 RS-232 Converter ...
The drivers seemed fine and I was using the right baud rate.
I'm unsure of the chip in the cable. It was this one from Amazon. Is it most likely the cable? I'll order an FTDI compatible one.
RELPER USB 2.0 to Serial (9-Pin) DB-9 RS-232 Converter ...
- Fri Sep 01, 2017 12:52 am
- Forum: Tuning Software
- Topic: Connecting MS V3 to TunerStudio MS?!
- Replies: 5
- Views: 3065
Connecting MS V3 to TunerStudio MS?!
Hi guys,
Really basic I'm sure, but I can't connect my Microsquirt V3 to TunerStudio. I'm using a USB-Serial adaptor and have been through loads of port COM settings. Do I actually have to try 1-99 (or more)? What should I be doing or looking for when I test each one? Have the car running or just ...
Really basic I'm sure, but I can't connect my Microsquirt V3 to TunerStudio. I'm using a USB-Serial adaptor and have been through loads of port COM settings. Do I actually have to try 1-99 (or more)? What should I be doing or looking for when I test each one? Have the car running or just ...