Thanks, Matt. I figured it might be that.
happy New Year
Tom
Search found 5 matches
- Tue Dec 29, 2015 12:05 pm
- Forum: Injectors, Fuel & Air Supply
- Topic: Injectors won't close of priming
- Replies: 6
- Views: 3156
- Wed Dec 23, 2015 5:53 am
- Forum: Injectors, Fuel & Air Supply
- Topic: Injectors won't close of priming
- Replies: 6
- Views: 3156
Re: Injectors won't close of priming
Matt,
Brain not engaged due to onset of Christmas! Previous measurements made to vehicle ground which of course is not connected with plug removed! Pin9 to pin 23 =76 ohms pin, 10 to pin 23 =23 ohms.
Tom
Brain not engaged due to onset of Christmas! Previous measurements made to vehicle ground which of course is not connected with plug removed! Pin9 to pin 23 =76 ohms pin, 10 to pin 23 =23 ohms.
Tom
- Wed Dec 23, 2015 4:54 am
- Forum: Injectors, Fuel & Air Supply
- Topic: Injectors won't close of priming
- Replies: 6
- Views: 3156
Re: Injectors won't close of priming
Matt,
Thanks for the response. Since my last post(s) I rewired the injectors so that they all (4) worked off pin 10 and I was really pleased when the engine started and seemed to run OK. However on the second run I found that the same symptom has now afflicted pin 10 and all the injectors are open ...
Thanks for the response. Since my last post(s) I rewired the injectors so that they all (4) worked off pin 10 and I was really pleased when the engine started and seemed to run OK. However on the second run I found that the same symptom has now afflicted pin 10 and all the injectors are open ...
- Sat Dec 19, 2015 10:35 am
- Forum: Injectors, Fuel & Air Supply
- Topic: Injectors won't close of priming
- Replies: 6
- Views: 3156
Inj 1 permenantly on
I seem to have a problem that Inj 1 (pin 9) is constantly firing the injectors. At power on inj 1 gives 12.3 v and doesn't turn off after 2 secs whereas inj 2 gives about 9v, presumably due to the PWM and turns off after 2 secs. When cranking Inj 2 pulses but inj 1 just keeps running all the time. I ...
- Sat Dec 19, 2015 5:58 am
- Forum: Injectors, Fuel & Air Supply
- Topic: Injectors won't close of priming
- Replies: 6
- Views: 3156
Injectors won't close of priming
On initial power up the pump runs for 2 secs and the injectors open but don't close leading to flooding. I've obviously made some changes to something as they were functioning correctly. Where is a good place to start looking. Can I disable priming?
Tommy
Tommy