Also just noticed another post on this very forum with the following details for wiring the EDIS;
Ampseal pin #12 to the SAW pin (#3) on the ignition module
Ampseal OPTOIN+ pin #30 to the PIP pin (#1) on the ignition module
Ampseal OPTOIN- pin #31 to the same ground location as the EDIS module (pin ...
Search found 2 matches
- Sat Mar 21, 2015 3:48 am
- Forum: Installation, Wiring and Sensors
- Topic: EDIS wiring help please
- Replies: 4
- Views: 972
- Sat Mar 21, 2015 3:40 am
- Forum: Installation, Wiring and Sensors
- Topic: EDIS wiring help please
- Replies: 4
- Views: 972
Re: EDIS wiring help please
am I correct in assuming the EDIS 4 and 8 are similar and can either connect the PIP to pin 30 or pin 32?
I have just finished installing a MicroV3 with EDIS 8 to my rover v8 but I cannot get any cranking rpm or the engine to start.
I have mine connected PIP to pin30 (OptIN+, grey/red) & SAW to ...
I have just finished installing a MicroV3 with EDIS 8 to my rover v8 but I cannot get any cranking rpm or the engine to start.
I have mine connected PIP to pin30 (OptIN+, grey/red) & SAW to ...