MicroSquirt.com read only forum (Jan.15,2018)

SOLVED

I think. Silly me, not reading all the pages correctly. I had forgotten abour the shunt resistor solder pads inside the case, so as a test i wired in an external 10k potentiometer across the VR pickup wires, fired it up and dialed in resistance until it revs cleanly with no resets. Magic ...

OK just been out and got some new 125a copper wire will remake the earths and be sure to only go between engine and battery and nothing else. Stopped in at jaycar but they were more or less useless on the capacitor front, since its running just fine up to 2200 ish rpm hopefully its not a bad signal ...

Much appreciated, thank you i have added it to the to do list. I niavely thought since its such a short run compared to a car I could get away with using the frame as an earth. I did earth everything together on one bolt, so even though the frame is earthed everything also has wire to run through ...

Gday, long time listener, first time caller. Have installed Microsquirt on my Kawasaki W800 and thrown a turbocharger in the mix for good measure. Have it starting nicely, idles and revs fine to around 2000rpm at which point it loses synch, cycles the fuel pump relay and settles back down again. If ...