MicroSquirt.com read only forum (Jan.15,2018)

After a brief pause for winter I am back at this continuing comms problem.

My friend inspected the MS and couldn't find and problem with the RS232 chip.

I have refitted it to the bike and the MS works well and the bike even starts and runs reasonably considering I had only put a basic map onto it ...

Thanks for all your help Matt!

I will be dropping it off with my Electronics Dave tomorrow for him to look at.

Cheers

John

Hi Matt

Its the V2.0 black pcb. I Have an electronics friend who has oscilloscope and all required facilities (his business designs and builds electronic audio equipment inc pcb's and writing software) for circuit board repair but he is usually very busy so it would be good if I can show him what ...

Thanks for the suggestions Matt, I tried reloading the firmware and am still getting no connection to the MS.
Could you point me in the right direction for fault finding on the circuit board?

Cheers

John

Hi Guys

I have got an interesting comms problem which is that I had ms tuner working fine and connected to my bike without any problems and I then tried to change my laptop as my old one was a bit slow. I have been unable to connect to the new laptop and whilst troubleshooting the problem I ...

i dont think there could be any way it could have got damaged as i didn't even move the bike or pc ... just unplugged the serial cable from the bike and put the bike on charge

you can see in this picture where the bike stays and im working on the pc (the garage got a tidy up after the photo was ...

evening guys
I have been building up my bike for a while now i have finally got up to fitting the MS but after doing all the wiring and testing out the MS i have hit a dead end ... i have got comms problems. At first i had no problems with MT connecting to the MS but after playing around with the ...