MicroSquirt.com read only forum (Jan.15,2018)

finally got it to start but now seem to be having a problem with it running lean. read the tuning section and din't really find anything. it ask for the map KPA in the table generators. This engine is not available in fuel injection so how would I know what those tables are suppose to be.

As well ...

we did the downloader program and are running 2.886 do i still need to change more in the ini files to get rid of te warnings.. if i leave it the way it is will i have difficulties later on or can i just ingnore the warnings?

oh and the 'constants i was wondering about is that i read over the ...

hey thanks for the help!!! we used the downloader program that u previously suggested and now we have communication. if you don't mind me asking can you maybe walk me through some steps to get it to fire...... you've been so helpful so far. like what r the things that i need to set for sure once i ...

need help. finally did the downloader program and are running the right code in the ECU. now both the megatune program and the microsquirt are reading correct files.....NEW PROBLEM...... still getting warning about n2o undefined value & map/baro undefined when we start the program up. that is one ...

looking for help. i think the communication issues i am having for one is i'm not coming up with anything in the port checker. 3 valid ports but no communication. we wanted to address the issue of microsquirt reading the right files but are not getting any communication.

it's very important that i ...

hope those helping aren't getting as frustrated as us..... we've set the ecu initially before we did the injector test mode. do we have to reset it after? and i can't reset it if we don't have any communication. have you seen that before. we were getting comminication until we did a sensor ...

hey checked everything ....ECU is 2.88 , program we're running is 2.886. we couldn't find a file for just 2.88.

the bike is a 79 hd sportster it runs wasted spark, i am running ford cops from a 4.6 v8 off of a crane
hi-4 ignition.

when i open megatune iget two error codes conditional check references undefined value n2o and the same except map/baro. i suspect the knock issue is that i never burnt to controller any knock related values as i am running fuel only and dont have a knock sensor. as for the map/baro i am clueless

hi , today i changed my map sensor got a signal then did a injector test that i could not shut off??? then after i got everything back to normal i lost communication again. when i turn my ignition on my fuel pump relay is cycling .my port checker doesnt show anything . again frustrated.