Search found 4 matches

Go to advanced search

by Jonas N
Thu Jul 27, 2006 4:35 pm
Forum: Tuning Fuel and Air
Topic: MsII not read LC-1 Value correctly and then Died help??
Replies: 3
Views: 441

Today i get the LC-1 Programmer software to work and i program a
0V 10:1 and 5V 20:1

Re callibrate the AFR in Mega Tune 0-5 Voltage and 10-20 AFR

Then just for check it i program LC-1 to put out a linear voltage just for be abel to read the AFR in mega tune and get this values.

0v 10:1 Corect ...
by Jonas N
Wed Jul 26, 2006 2:55 pm
Forum: Tuning Fuel and Air
Topic: MsII not read LC-1 Value correctly and then Died help??
Replies: 3
Views: 441

MsII not read LC-1 Value correctly and then Died help??

Hi

Have LC-1 And MSII V2.2 board.

I have done the free air calibrate and it seems to work fine.
Warmup works and led light steady when its ready to opperate.

I use the 2 anlog output with the 470 ohm resistor. If i messure the voltage i have 5 V out from the LC-1 in the free air. When i read in ...
by Jonas N
Wed Jul 26, 2006 5:55 am
Forum: Ignition Setup, Tuning, and Troubleshooting
Topic: Edis 4 send short 25500 rpm peak signal to Ms.Whats wrong?
Replies: 2
Views: 430

Have change to Ms II and it seem to work fine now.
by Jonas N
Thu Jul 20, 2006 3:21 pm
Forum: Ignition Setup, Tuning, and Troubleshooting
Topic: Edis 4 send short 25500 rpm peak signal to Ms.Whats wrong?
Replies: 2
Views: 430

Edis 4 send short 25500 rpm peak signal to Ms.Whats wrong?

Hi

Have a Edis 4 and MS V2.2

And when connect power to the Edis module it send a short high rpm (25500 rpm) signal to Ms. For about one second.Then it dissaper for 2 seconds.And so on.

The injector runs at 170% and the pulse width is same as Cranking value. Somtimes littel higer.
Baecause the ...

Go to advanced search