MicroSquirt.com read only forum (Jan.15,2018)

fscott wrote:

andtho wrote: What should I do? Short sircuit these to points with i wire or something?

Yes.

As i thought, I always say that it is better to ask and get something verified then not to ask at all and do something wrong..

Okey!
I read the info on how to flash the card with new code, it says that I have to power down the card and press the Boot jumper. I cant find anything that resembles a boot jumper on my card. I see the text "boot" printed on the card, but there isnt anything "welded" to the card at these to points ...

Anders,

For the processor, see the FAQ: http://www.megamanual.com/MS%20FAQ.htm#whatis (thee are illustrations and other info).

For the code, if you have an MS-II, you would have had to load the code yourself. For MS-I, if you did not load code, the you have V3.000 code from B&G.

In any case ...

andtho,

Typically there are two probable causes for this:

- a low battery voltage that causes the values not to get burned to the flash memory, or

- an incorrect INI file that scrambles the values when the are written, putting many of them in the wrong places.

What processor and code are you ...

I have a problem with my MS 2.2 V3, I have wired it into the original engine wiring in my Ford Sierra 2 liter turbo. It seems that the wiring is correct so I am worried that the problem lies with a faulty MS card..

The problem is this, I enter all the information in VE table, enrichments. Burn it ...