MicroSquirt.com read only forum (Jan.15,2018)

Well the guy that I based my chart off of (very similar setup) said he hits 10lbs at 3100rpm, so I must have a leak somewhere.... do a boost leak test,
then get your a/f closer to 12.5:1 around 0 psi to about 3psi

then get to a dyno and start bumping the timing up until you stop making anymore tq ...

OK i know you guys are going to ask me a few questions

-what are my air/fuels well that are in the 10s around the time the car breaks up
-what boost levels the car breaks up in any boost as long as i am giving the car load it happens
-what are my plugs gapped at they are gapped at .028
-what is my ...

you could run the msns-e code and have a 12 x 12 map

here is the webpage
http://megasquirt.sourceforge.net/extra

richie

Ok i am trying to use the stock ignition setup on this motor do you think i can make it work, and if so what MS verison should i use

thanks
richie

just turn up your req fuel and then take out the extra fun at ilde and cruising

Ok we are working on getting a car with a Hall Effect Sensor and 60-2 running spark on MSnS-E with wheel code setup

My first question is what is a trigger angle and how do we figure it out?

Second question is how do we go about finding the trigger positions?

Also how do we determine the dwell ...

Ok, your stock ECU is controlling Spark. It will work to just disconnect the injectors from the stock ECU and run them with Megasquirt, People do this all the time, you need to be carefull to not disconnect from your stock ECU any of the stock sensors that could effect the timing.

Did you do ...

Richie,

That injector hookup sounds like it should work fine. although what i normally do is take two 20gauge wires and hook to 32 and 33, and splice to one 14 guage wire routed to one bank of injectors, vice versa for INJ2. Your method of using a single injector per pin should work out fine.

It ...

ok, here is my question, i was wondering how people know the order of the the injectors when hooking them up
i have seen wiring diagrams showing them hooked as:
1,2,3,4
1,4,2,3
1,3,2,4


i was wondering how i know hook them up

I am running MSnS-e fuel only on a car that is firing ordering is 1,4 ...

ok, here is my question, i was wondering how people know the order of the the injectors when hooking them up
i have seen wiring diagrams showing them hooked as:
1,2,3,4
1,4,2,3
1,3,2,4


i was wondering how i know hook them up

I am running MSnS-e fuel only on a car that is firing ordering is 1,4,2 ...