MicroSquirt.com read only forum (Jan.15,2018)

should i have 2 have it connected 2 the controller 2 do this

steve

i tryed to print a screen shot and my conputer dosent do any thing when i press alt prt-sc and i looked at ur tina its a bit o a monster id like 2 get a mk2 16e but good ones r har 2 find now

steve

once u genarated a ve using my data did u look on tunning ve and c the spread of kpa bins

steve

torque 190 hp 210 turbo and i idle @35 kpa but when i rev and lift of kpa dips in 2 hi 20s so i thought id best have it lo is this wrong and thanks for ur time

steve

i have just tried 2 start again and my new ve table all the binns are squashed at low end of kpa am i doin somethin wrong i entered 20 kpa at idle and 200 kpa @2750rpm 200kpa@6750 and red line 200@700 on a 115cid can someone try this an tell wot happens as i had a ve table already on my pre built ...

yes id already done this but reading mega manuel it says.


Note: If you do not use the “correct” REQ_FUEL value, the VE numbers in the VE table will be skewed by the amount REQ_FUEL is “incorrect”.

so i thought it was wrong and changed it back how confuseing is that manuel

wot did u do can u tell me i c how i get on

alright 132

y cant u get bigger injectors r they hard 2 come by in egipt

steve aka stv firestarter

if i get it sorted i let u know and if anyone can help please leave step by step instructions thanks im a megastuck


steve

i have looked all through the manuel and cant seem 2 see any thing about scaling the ve table