MicroSquirt.com read only forum (Jan.15,2018)

Yup as you say, it's a red V1.0 and the 2.9 code loads fine.
Oh well, I'm sure I'll find a use for it on something.

Lance, this is a microsquirt that I'm trying to bring back to life.
Rgrds

I dug out my early usquirt in a vain attempt to see if this new code would magically fix the injector driver issues
Any tips to get this loaded

Great news, I was beginning to think MAF sensors were out of ‘fashion’.

I’ve been running MAF for a while now and as you say they are so easy to tune via the correction table even though I’m stuck with the default curve (for now).

I’d be up for some testing if you need volunteers. Keep ...

From the instructions at http://www.microsquirt.info/mafmap.htm

If you select one of the MAF options, you must input a MAF sensor calibration curve (or use the default Ford curve.)
If this is not feasible, then a shorter correction table is provided as a tuning input.
Can anyone tell me where ...

Unresolved

S'pose I could always re-brand it as a Micro-Jolt

And it would be a good option for anyone that has killed one.

Stumped. When I short Pins 3 & 4 on U6 & U7 with the ammeter I get a nice click from the injectors and pull a healthy 2.69amps & 2.72 amps respectively. I used the scope between U6 Pin 1 and ground but didn’t make much sense of it. In Injector Test Mode there seems to be about 1volt oscillating ...

Cranking looks good as per attached, if a little sluggish.

I ran the Injector Test Mode (20msec PW, 60msec offtime) and could hear the injectors making the faintest of clicks. Test meter showed almost 1 volt across the HiZ injector. When I replaced it with a small 12v test bulb it glowed very very ...