Fuel injecting a yamaha banshee

This forum is for discussion of MicroSquirt (TM) from Bowling and Grippo. The MicroSquirt information site is at www.usEasyDocs.com
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
dusty_v141
MegaSquirt Newbie
Posts: 2
Joined: Sat Aug 14, 2010 2:40 pm

Fuel injecting a yamaha banshee

Post by dusty_v141 »

he guys im going too fuel inject a 1987 yamaha banshee 2-stroke. its a twin cylinder with one coil and two plug wires. the coil fires both plugs at the same time. the ignition system is setup on a stator so there is no battery. know im going too have toon put one on. but my question is what all am i going too need too make this system work. thanks guys
mxrob
Helpful Squirter
Posts: 44
Joined: Thu Dec 24, 2009 5:43 pm
Location: Kentwood, MI
Contact:

Re: Fuel injecting a yamaha banshee

Post by mxrob »

Good luck on your project. I'm thinking this might be of some help..... 8) Make sure you Image to Steve for making your life a whole lot easier.

http://www.smcomp.com/~smurph/RZ-EFI/index.html

Here's the link to his project over on MS Success Stories/motorcycles:

http://www.msruns.com/viewtopic.php?f=93&t=22238
DR650 Dual Sport thumper µs FI success!
dusty_v141
MegaSquirt Newbie
Posts: 2
Joined: Sat Aug 14, 2010 2:40 pm

Re: Fuel injecting a yamaha banshee

Post by dusty_v141 »

thanks man i have one read that article several times.
Post Reply