Hi again. so it was suggested that i try the injector test mode to see if the injectors were working. we did this and were successful. however now the problem stands that I can get out of test mode. now when we power the bike the injectors believe that they are still in test mode.
I've tried resetting it and fetching it from the ECU and resetting it i've even tried quitting the program without saving but with NO success. How do i get it back to NO TEST MODE......
can't get out of injector test mode???
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
SQLGUY
- Experienced Squirter
- Posts: 243
- Joined: Sun May 14, 2006 3:03 am
- Location: Colorado Springs, CO
Re: can't get out of injector test mode???
Sounds like you're running an older version of the firmware. There was an issue with injector test mode not resetting, and that was fixed around 2.884j or so. What version are you on?
Re: can't get out of injector test mode???
i believe we're running 2.88 does that mean i'm screwed>>>
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: can't get out of injector test mode???
Yes, you are. Reloading the code will get it out of injector test mode though.
Matt Cramer at DIY Autotune
