There was a post a while ago where someone had used a digital volt gauge to display the afr. it was being used on the LC1 set up.
would this work on the tech edge wideband system as well. the com lead out of the unit has a serial connector using a send and receive wire plus an earth
AFR DISPLAY
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.