Page 1 of 2
can MS II control waste spark DLI without any EDIS module?
Posted: Mon Sep 11, 2006 10:12 pm
by CHB
can MSII control a waste spark DLI without any EDIS module? currently there is only 1 Ignition output from the DB37. i wonder we can configure other additional ports to do the coil packs control?
can MS II control waste spark DLI without any EDIS module?
Posted: Mon Sep 11, 2006 10:13 pm
by CHB
can MSII control a waste spark DLI without any EDIS module? currently there is only 1 Ignition output from the DB37. i wonder we can configure other additional ports to do the coil packs control?
Posted by email.
Posted: Tue Sep 12, 2006 1:27 am
by jsmcortina
Toyota DLI ? You don't say.
That is supported by MS1/Extra but not yet MS2, it should make it into MS2/Extra at some point.
James
can MS II control waste spark DLI without any EDIS module?
Posted: Tue Sep 12, 2006 1:27 am
by jsmcortina
Toyota DLI ? You don't say. That is supported by MS1/Extra but not yet MS2, it should make it into MS2/Extra at some point. James
My Success story
http://www.msefi.com/viewtopic.php?t=8008 MS1/Extra at:
http://megasquirt.sourceforge.net/extra
Posted by email.
can MS II control waste spark DLI without any EDIS module?
Posted: Tue Sep 12, 2006 1:27 am
by jsmcortina
Toyota DLI ? You don't say. That is supported by MS1/Extra but not yet MS2, it should make it into MS2/Extra at some point. James
My Success story
http://www.msefi.com/viewtopic.php?t=8008 MS1/Extra at:
http://megasquirt.sourceforge.net/extra
Posted by email.
Posted: Tue Sep 12, 2006 1:39 am
by CHB
its very hard to get a toyota GZE or 7MGTE DLI module.. so i'm looking an alternative ways to get my 3TC waste sparked..
can MS II control waste spark DLI without any EDIS module?
Posted: Tue Sep 12, 2006 1:40 am
by CHB
its very hard to get a toyota GZE or 7MGTE DLI module.. so i'm looking an alternative ways to get my 3TC waste sparked..
Posted by email.
Posted: Tue Sep 12, 2006 12:41 pm
by jsmcortina
What is a 3TC ?
You are going to have to ask your question a lot more clearly to get the answer you want.
What are you _actually_ trying to do?
James
can MS II control waste spark DLI without any EDIS module?
Posted: Tue Sep 12, 2006 12:41 pm
by jsmcortina
What is a 3TC ? You are going to have to ask your question a lot more clearly to get the answer you want. What are you _actually_ trying to do? James
My Success story
http://www.msefi.com/viewtopic.php?t=8008 MS1/Extra at:
http://megasquirt.sourceforge.net/extra
Posted by email.
Posted: Tue Sep 12, 2006 4:06 pm
by CHB
ok ok.. i'm using MS II on my toyota 3TC engine. it has a distributor to do the spark distribution.. now i try to get rid of it and plan to setup a DLI system from MS II