MicroSquirt.com read only forum (Jan.15,2018)

Posted: **Thu Jun 29, 2006 9:58 pm**

running cyl head sender and it goes of wue at to low of temp anybody know how to set the temps higher. MS II v3.0 code 2.36

Posted: **Mon Jul 03, 2006 5:27 pm**

How do I change warmup temps

Turbo nut,

You can only do this if you enable either the PWM or stepper IAC idle control (at least temporarily) under Idle Control/Algorithm.

Then go to the Idle steps (or PWM Duty Cycle) under Tables and you can change the temperature bins there (they take effect everywhere after that).

Then you can set the Idle control to whatever you want, including 'none'. You have to enable the idle controller any time you want to change the values, so if you plan to experiment you might want to leave it on one of the idle controllers.

Lance.

Posted: **Wed Jul 05, 2006 2:28 pm**

This one stumped me also when I first started.

A.J.