can i use the 1 coil per cylinder setup as on the modern sport bikes with the megasquirt 1 V3.0 board,
its had all the mods to run the crank angle sensor on a mazda mx5 (miata) (the dsm mods)
its firmware is the 029q2 ms+se
if i can, would i wire it any differently than standard?
1 coil per cylinder
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
stevenford_uk
- MegaSquirt Newbie
- Posts: 4
- Joined: Sat Jul 23, 2005 3:21 pm
- Location: england
1 coil per cylinder
1992 eunos roadster v-spec
stainless tubular manifold
stainless system
fully ported and polished
need help with throttle body issues
stainless tubular manifold
stainless system
fully ported and polished
need help with throttle body issues