Page 1 of 1
C64 direct replacement for 1st gen MSII?
Posted: Tue Jun 06, 2006 3:30 pm
by tony2ltr
I Have a 1st Gen MSII setup with EDIS on my Cosworth Vega, I am now realising that it isn't going to be able to do some of the things I want it to.
Is the C64 version a direct replacement for the forst version? or will I have to rewire my V2 board?
Posted: Wed Jun 07, 2006 1:13 am
by jsmcortina
Externally the wiring will be the same, the C64 based MS2 adds some more pin functions, it is very unlikely that you have these connected, but might be worth a double check.
James
!
Posted: Wed Jun 07, 2006 4:47 am
by tony2ltr
I am still building this car, but it is very very close to firing up for the first time. The only thing I have connected so far is the EDIS. This is a turbo car, so eventually, I want to be able to control:
secondary injection
Water injection
maybe idle air bypass
electric fans
speed sensors/fuel economy gauge in MT
All these things are possible with MSII and the GPIO board right?