Page 1 of 1
toyota ignition set-up
Posted: Mon Feb 27, 2006 8:53 am
by lospeed
What is the best ignition set-up to be used for MS2 V3?
i want to used the stock distributor of my 4age..the dizzy pin-outs are "Ne,G1,G2,G-" .I think the dizzy signal is the same as 3sge .
can anybody enlighten me..
Posted: Mon Feb 27, 2006 12:03 pm
by muythaibxr
You won't be able to use the stock distributor with MS2 yet.
Try msns-extra as it should be able to work.
Posted: Tue Feb 28, 2006 4:40 am
by lospeed
is msns-extra will work on MS2 ?
also ,what kind of dizzy signal input will MS2 work? is it using 36-1 whell tooth
Posted: Tue Feb 28, 2006 6:18 am
by Matt Cramer
lospeed wrote:is msns-extra will work on MS2 ?
No.
also ,what kind of dizzy signal input will MS2 work? is it using 36-1 whell tooth
Currently, one pulse per ignition firing. A distributor or cam-mounted trigger with four teeth spaced 90 degrees apart will work. So will a crank trigger with two teeth spaced 180 degrees apart. Work on a wheel decoder that can handle other tooth counts is under way.
A 36-1 wheel would work with a Ford EDIS setup.
Posted: Tue Feb 28, 2006 7:13 am
by lospeed
thanks a lot..
thats the information i need...
also ,has anybody sucessfully used with two teeth spaced 180 degrees set up in their stock toyota dizzy?
Posted: Tue Feb 28, 2006 7:26 am
by ivanlau78
i'm using G1 4 tooth signal and get the correct RPM signal. NE won't work. but the car still not able to start yet.
not too sure how the ignition setting for toyota 4age.