Fuel injection timing?
Posted: Thu Feb 09, 2006 11:25 pm
It would be nice feature to have fuel injection timing - specially with my siamese port engine 
.
.MicroSquirt.com read only forum (Jan.15,2018)
Read only forum for MicroSquirt(R) from Bowling and Grippo
http://microsquirt.com/
Fuel injection timing?
Page 1 of 1
Posted: Fri Feb 10, 2006 2:19 am
I think this will be possible with the up and coming GPIO board.
Posted: Fri Feb 10, 2006 3:53 am
There is an alpha version of a siamese-port code for MS-II.
Have a look at http://www.msefi.com/viewtopic.php?t=14617
Jean
Have a look at http://www.msefi.com/viewtopic.php?t=14617
Jean
Posted: Fri Feb 10, 2006 4:40 am
You could also run duel table with table 2 running slightly richer or whatever. The tough part is figuring what is the correct adjustment. I have never thoought about running 2 O2s one on each header tube. The first running channel 1 and the other running channel. The Harley may be a good source for thoughts.
AW
AW
Posted: Fri Feb 10, 2006 7:43 am
Jeff,jcorsaro wrote:I think this will be possible with the up and coming GPIO board.
You are thinking of the Router board, GPIO does slow non-synchronous stuff.
Eric
Posted: Fri Feb 10, 2006 7:46 am
I know the Ford Probe/Mazda MX-6 guys sometimes do this on the transverse V-6 motor, using dual table and two EGO sensors.whittlebeast wrote:I have never thoought about running 2 O2s one on each header tube. The first running channel 1 and the other running channel. The Harley may be a good source for thoughts.
Eric
Posted: Fri Feb 10, 2006 9:43 am
Interesting.
I intend to tune my H-D sportster powered bike this weekend. Dual table driven by two O2s would be interesting. It would be interesting to see how it attempted to trim each cylinder.
Damn! Now I have another project and I haven't even got to ignition yet!!!
I intend to tune my H-D sportster powered bike this weekend. Dual table driven by two O2s would be interesting. It would be interesting to see how it attempted to trim each cylinder.
Damn! Now I have another project and I haven't even got to ignition yet!!!
Posted: Fri Feb 10, 2006 2:14 pm
Craig, I'll be going to get my sporty next weekend. This spring sometime I have a buddy wanting me to build a MS controller and for that he'll spring for two kits so I'll be eyeballing the bike real soon. What year is yours?