MicroSquirt.com read only forum (Jan.15,2018)

To all of the people being added to the bata list....Be very carful using bata code. Strange things happen. Try to always run the code with an inport of your MSQ an play with things first on a stim. If that looks as expected then try things very slowly on the car. Don't assume anything. I like to have a person experanced at watching and tuning Squirts watching the gauges on the first drive.

Over the years I have seen instant motor kills, gauges going the wrong way, fuel being added when the motor and o2s requested less, no start, strang misses even though everything looked fine. Point be carfull and have fun. Always have the attitude that you are tring to help Bruce, Al, Lance, James, Ken, Rodger(Palm), Phil and Phil, make this all better.

AW

Point well noted and appreciated!

When will the new code will be availible for everyone.

Nick,

That depends when it is sorted out, which can be tricky to predict. The short answer is 'soon, barring complications'.

The plan is tentatively for this to happen in the next week or two, if all goes well.

Lance.

Lance could you add me to the beta group.
I am running a V3 board with a custom interface to the factory harness (like Johnc). I have been running the 2.672 code for a couple of months. I just uploaded 2.683 the other day. No issues as of yet.
Installed MSII back in Jan 06, never have had any real problems with my install.

90'VW Corrado G60 2.0L