MicroSquirt.com read only forum (Jan.15,2018)

Code: Select all

[AutoTune]
#if MS_I
   table = veTableMap ; Should be the map3d_id of a TableEditor entry.
      allowAutoTune = on            ; Displays the check box on the specified tuning dialog.
      corrector     = egoCorrection ; Variable used for correction algorithm.

      ; Tuning block parameters
      ;    Global limits on tuning, outside the box and nothing happens.
      xLimits = 1500, 4000 ; RPM
      yLimits =   60,   90 ; MAP
      zLimits =   10,  200 ; VE

      ; Vertex tolerance parameters
      ;   How close you must be to a vertex before tuning takes place.
      xRadius = 200 ; RPM
      yRadius =   7 ; MAP

      ; Controller parameters
      initialStartupInterval = 1.0 ; Seconds before first adjustment
      updateInterval         = 1.0 ; Seconds between each consecutive adjustment.
      proportionalGain       = 0.5 ; Proportion of (100-corrector) to use for adjustment.
      lumpiness              = 5   ; Maximum percent adjustment above or below neighboring VE points.