warm up problem

For discussing MicroSquirt (TM) configuration and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
rs turbo
MegaSquirt Newbie
Posts: 2
Joined: Sat Sep 04, 2004 10:10 am

warm up problem

Post by rs turbo »

hi to all i have instaled ms-1 with the v3 code on a mazda engine the car ideals great but the warm up always stays at 130% also when colat temp are 78-82c what can be wrong?
Top
efahl
Site Admin
Posts: 232
Joined: Mon Feb 16, 2004 3:15 pm
Location: San Clemente, California, USA
Contact:
Contact efahl

Post by efahl »

Sounds like you are using a non-GM coolant temperature sensor and have not calibrated it.

Eric
Top
rs turbo
MegaSquirt Newbie
Posts: 2
Joined: Sat Sep 04, 2004 10:10 am

Post by rs turbo »

i am using denso sensors but changed the resistors like advised in the manual and the reading are true i.e it shows the actual temp the diff betwen the outside temp is 2-3 degre c also i have "cloased" all the enrichments 100% at all temps and AE to o so it is strange the car ideals a bit rich :( :( and the warm up is working
Top
Post Reply

Return to “Tuning Fuel and Air”