Microsquirt and Haltech IQ3 dash? Couple of other Q's

[Birdoprey]

Hello gentlemen,

I'M picking up a new bike in a few weeks. It's a 2000 Bandit 1200 with a MCXpress intercooled turbo kit. It blows through the stk carbs and puts down 287RWHP with c16 race gas at 18psi. Stk CV carbs are 36mm. Plans are to convert to fuel injection using GSXR750 or 1000 TB's. Soon after I plan to run Haltech's IQ3 dash. Can the Microsquirt be used with the IQ3 dash?
Would the Microsquirt work well with my turbo application? Looking at the specs it seems like it will fit the bill, but I don't wanna be overlooking anything.
Plans are to run fuel only, the run ignition later on.

Thanks in advance!

-Mark

[24c]

Mark,
The Haltech IQ3 is a branded version of the RacePak IQ3 Dash, and they sell a MS2 module that uses the DB9 serial port AFAIK. I think the guy at RacePak aka Tim, was working on the CAN versions, but maybe this was for MS3. Matt at DIYAutotune sells the interface module too, and he has a PDF here explaining the outputs etc
Cheers
Mike

[Matt Cramer]

Clarification - we do not currently sell the Racepak module. We've discussed it but it currently does not support the new serial protocol used in the current release of MS2/Extra or MS3 firmware.