60-2 trigger punto gt

papagias · Post by **papagias** » Wed Jan 07, 2015 7:59 am

hi i have a problem with oem hardware on punto gt it revs until 6800 and then lost sync i have tried diferent resistances

Matt Cramer · Post by **Matt Cramer** » Thu Jan 08, 2015 5:55 am

Exactly what resistors have you tried and where were they connected?

Is this a V3.0 (plastic case) or an earlier MicroSquirt?

papagias · Post by **papagias** » Thu Jan 08, 2015 7:53 am

it s v3 and i have connect resistors in line to vr sensor 10-15-20-25-30kohm

Matt Cramer · Post by **Matt Cramer** » Mon Jan 12, 2015 10:15 am

Try using a 10K resistor across the two wires instead of inline.

papagias · Post by **papagias** » Tue Jan 13, 2015 11:10 am

i tried this the same thing. i ve tried also firmware update to 3.83 from 3.3.1 but ihave to read the manual for the trigger configuration

Matt Cramer · Post by **Matt Cramer** » Wed Jan 14, 2015 6:58 am

If running the Extra code, see if you can get a tooth log of the breakup and post it here.

papagias · Post by **papagias** » Wed Jan 14, 2015 1:28 pm

after the update i cant go to diagnostics and high speed loggers but i have one from the old firmware 3.3.1

Matt Cramer · Post by **Matt Cramer** » Thu Jan 15, 2015 6:12 am

Try a 4.7K or lower resistance value instead, in parallel with the sensor.

papagias · Post by **papagias** » Fri Jan 16, 2015 2:06 pm

i tried no luck i m going to try ahall efect sensor this solotion is good for some other ecus

MicroSquirt.com read only forum (Jan.15,2018)