edis with micro?

chango de naranjito · Post by **chango de naranjito** » Sat Jan 27, 2007 2:45 pm

Hi can I run edis with micro? and how? thanks

Post by **grippo** » Sun Jan 28, 2007 12:29 pm

Yes you should be able to - just leave the Dual Spark Option off. I don't think there is any special wiring for EDIS that the V3 board has but microsquirt doesn't.

chango de naranjito · Post by **chango de naranjito** » Sun Jan 28, 2007 5:34 pm

do you know the pins and coneccions? in the manual only says the coneccion for the megasquirt 2

MegaScott · Post by **MegaScott** » Sun Jan 28, 2007 8:27 pm

chango de naranjito wrote:do you know the pins and coneccions? in the manual only says the coneccion for the megasquirt 2

You only have to worry about the PIP and the SAW.

The PIP of the EDIS module connects to the Optoin+, and the Optoin- you hook to ground.

For the SAW you want to connect the "Ignition output 1" to the SAW connection of the EDIS module, with a 1k pullup resistor to the 5VREF wire.

I hope to be connecting this up to my truck tomorrow, to test it out.

chango de naranjito · Post by **chango de naranjito** » Mon Jan 29, 2007 6:41 pm

thanks, I will experiment with a rotary 13b.Maybe in the sumer but I want as much information as posible, the car will look something like this

chango de naranjito · Post by **chango de naranjito** » Mon Jan 29, 2007 6:54 pm

i will run 2 edis modules 1 leading 1 fro trailing with 2 vr sensors tell me how it work for you