Mircro Squirt triggering, help needed!!

This forum is for discussion of MicroSquirt (TM) from Bowling and Grippo. The MicroSquirt information site is at www.usEasyDocs.com
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
vmaxmitch
MegaSquirt Newbie
Posts: 6
Joined: Tue Dec 05, 2006 11:59 am
Location: Switzerland

Mircro Squirt triggering, help needed!!

Post by vmaxmitch »

Hi guys!

I was reading through the Mircro Squirt manuals and checking the wiring schematic. I couldn't find how the uS was triggered.

I'm planning to install Micro Squirt on my motorbike (Yamaha Vmax, 4 pick-up coils, 4 coils, 1-3-2-4 firing sequence, odd fire). I'll just use Micro Squirt for fuel.

Mega Squirt is triggered via the coil's negative. What about micro squirt?

Thanks for your help.

Mitch
newtyres1
Helpful Squirter
Posts: 139
Joined: Mon Feb 06, 2006 7:32 pm
Location: Brisbane, Australia

Post by newtyres1 »

The MicroSquirt has an "Opto In" very similar to a standard MegaSquirt. It's not covered that well yet in the docs being so new (well - not released quite yet!), but I assume it would be wired up the same, and the VR1+ and VR2+ inputs connected to ground. (Best to wait for more info).

http://www.microsquirt.info/uswiring.htm

and schematics here: http://www.microsquirt.info/ then click on "hardware".

Ian.
Dave Sloan
MegaSquirt Newbie
Posts: 13
Joined: Wed May 12, 2004 2:01 am
Location: Brisbane, queensland

Post by Dave Sloan »

Have a look at Neils V max I think that he may have the ignition side of things going or his listing in the sucess stories under motorcycles
http://www.saarloos.net/
vmaxmitch
MegaSquirt Newbie
Posts: 6
Joined: Tue Dec 05, 2006 11:59 am
Location: Switzerland

Post by vmaxmitch »

Thanks for your answers. I'll wait until the release. Can't wait, but looks kinda scary to figure out how to setup all the parameters (constants, VE table, etc).
coilmscoyle
MegaSquirt Newbie
Posts: 2
Joined: Thu Dec 14, 2006 6:38 am

Mircro Squirt triggering, help needed!!

Post by coilmscoyle »

Mitch,
I know that the ignition trigger on the Vision and the Max is an AC wave. The pickups are a coil and they generate when the steel bar on the flywheel passes by. With the Vision we could set polarity of the trigger signal to match what needs to be used in the uS. I think ignition and FI should be done with the uS just to give us the tunability that the stock ignition doesn't have. Do the VMax ignitions have 4 pickups?

Coil
vmaxmitch
MegaSquirt Newbie
Posts: 6
Joined: Tue Dec 05, 2006 11:59 am
Location: Switzerland

Post by vmaxmitch »

Hi Coil,

Up to 1989, the Vmax has an analog ingnition unit and 4 pickup coils. From 1990, it upgraded to digital and 1 pickup coil. I have an early 1986 model.

Mitch
Post Reply