Boost control

This forum is for discussion of MicroSquirt (TM) from Bowling and Grippo. The MicroSquirt information site is at www.usEasyDocs.com
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
gboezio
Helpful Squirter
Posts: 64
Joined: Mon Dec 04, 2006 9:15 am
Location: Victoriaville, QC, Canada

Boost control

Post by gboezio »

Is there any way to use the remaining wires of the microsquirt unit to control boost.
Turbo Honda VTR1000F on the way
Top
Matt Cramer
Super Squirter
Posts: 910
Joined: Sat Jul 03, 2004 11:35 am

Post by Matt Cramer »

It should be possible to use the LED output wires - there's two of them - as spare outputs. However, at the moment, there is no boost control code, so you will need a few tweaks to the embedded code to get boost control.
Matt Cramer at DIY Autotune
Image
Top
gboezio
Helpful Squirter
Posts: 64
Joined: Mon Dec 04, 2006 9:15 am
Location: Victoriaville, QC, Canada

Post by gboezio »

I'm glad to hear that, it will make things easier and perform better
I shure don't want the wastegate to crack at half the pressure since motorcycle dont stay on boost very long I would like to see full boost between shifts.

Thanks
Turbo Honda VTR1000F on the way
Top
Post Reply

Return to “MicroSquirt General Information”