how to scope out VR input on the board

This forum is for discussing ignition setup, tuning, and troubleshooting for MicroSquirt (TM)
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
ochizon
Helpful Squirter
Posts: 42
Joined: Mon Jan 16, 2006 1:59 pm

how to scope out VR input on the board

Post by ochizon »

MSNS-E board V3

Where do I tap my oscilloscope to see what the VR input is doing on the board?
Top
ares650
MegaSquirt Newbie
Posts: 9
Joined: Mon Jan 30, 2006 10:03 am
Location: miami, fl.

Post by ares650 »

Would it be Q22?
Top
ares650
MegaSquirt Newbie
Posts: 9
Joined: Mon Jan 30, 2006 10:03 am
Location: miami, fl.

Post by ares650 »

Anyone?
Top
zsilinszkyz
MegaSquirt Newbie
Posts: 3
Joined: Mon May 03, 2004 2:29 am

Post by zsilinszkyz »

Why don't you have a look at the schematics? You can easily follow the signal to the CPU.

Zoltan
Top
ares650
MegaSquirt Newbie
Posts: 9
Joined: Mon Jan 30, 2006 10:03 am
Location: miami, fl.

Post by ares650 »

zsilinszkyz wrote:Why don't you have a look at the schematics? You can easily follow the signal to the CPU.

Zoltan
Thanks that helped!!!!
Top
Post Reply

Return to “Ignition Setup, Tuning, and Troubleshooting”