Having trouble finding a spec for distance. What are we looking at? 1/16", 1/8" ?
I don't know,
Thanks for the help.
Lee
Spec for EDIS vr sensor to wheel distance
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Spec for EDIS vr sensor to wheel distance
"quinn" wrote:
> Having trouble finding a spec for distance. What are we looking at? 1/16", 1/8" ?
Cripes, you want it a lot closer than that. A constant distance throughout
the revolution is more important than absolute distances but somewhere in
the 0.5-1.5mm is what you should be looking at.
Posted by email.
> Having trouble finding a spec for distance. What are we looking at? 1/16", 1/8" ?
Cripes, you want it a lot closer than that. A constant distance throughout
the revolution is more important than absolute distances but somewhere in
the 0.5-1.5mm is what you should be looking at.
Posted by email.
-
Bernard Fife
- Super Squirter
- Posts: 1009
- Joined: Mon Feb 16, 2004 3:15 pm
quinn,
The EDIS section of the megamanual says,
Lance.
The EDIS section of the megamanual says,
This is here: http://www.megamanual.com/ms2/EDIS.htmNear the crank wheel is a Variable-Reluctance (VR) sensor - this sensor produces a bipolar signal. The VR sensor is pointed at the center of the crank wheel, with a 0.030 to 0.060 inch gap (0.75 mm to 1.5 mm) to the crank wheel teeth.
Lance.