I have the fuel pressure too low. It's only set at 32#'s when it should be at 42#'s. My Req Fuel and VE table are tuned for the wrong fuel pressure. Is there a calculation I can make to adjust everything at once so it will still run good? I tried to up the pressure to where it belongs and it just kept flooding even after lowering the req fuel. I got so frustrated I just loaded up an old program that I knew worked and went cruising around on auto tune.
Any ideas?
Running very good w/ autotune, buuut
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
G'day "Arrowhead"
I think if you open "VE Table" (where you set the VE constants) then select "Tools" then "VE Specific" you should see "Reset ReqFuel", this should do what you need, check this out for more info =>
http://www.megasquirt.info/megatune.htm#a1tvr
Cheers
DaveZZ
I think if you open "VE Table" (where you set the VE constants) then select "Tools" then "VE Specific" you should see "Reset ReqFuel", this should do what you need, check this out for more info =>
http://www.megasquirt.info/megatune.htm#a1tvr
Cheers
DaveZZ