Need MSQ for a turbocharged 4 Cylinder.. around 2.3L

Bossman · Post by **Bossman** » Wed Mar 08, 2006 8:16 pm

I want to see a good running turbo 2+litre 4 cylinder VE table.
I want to see how much higher than 100% VE is needed.

natesully · Post by **natesully** » Wed Mar 08, 2006 9:00 pm

Not very much, if your ReqFuel is set right. Mine goes to ~110%, and that's ultra rich. You should set your VE map up in the 120's around whatever you call high boost, and go from there. I used the map generator at first, and it worked really well- everything was too rich, so all I had to do was lean it out a little.

Skiericski · Post by **Skiericski** » Wed Mar 08, 2006 10:07 pm

This is a 2.6l 8V MPI engine(mitsubishi) I've only run it up to around 15 PSI so far, but it's pretty solid at around 11.5:1. My VE barely goes above 100.

Bossman · Post by **Bossman** » Thu Mar 09, 2006 10:12 pm

I would like to thank both you guys for your help. Very informative.