O2 wiring

mrzefect · Post by **mrzefect** » Sat Feb 25, 2006 1:37 am

How do i wire up a four wire o2 wide band sensor i only have wiring digram for a three wire narrow band one and is it essential to run a air temp sensor.

Bernard Fife · Post by **Bernard Fife** » Sat Feb 25, 2006 8:45 am

mrzefect,

A four wire sensor is a narrow band sensor, and has two separate circuits:

- a sensor circuit, with signal and ground leads,

- a heater circuit, with heater and ground leads.

See this page for more info:

http://www.thegebharts.com/o2sens.html

Wide band sensors have 5 or more wires, and require a separate controller board.

Lance.

mrzefect · Post by **mrzefect** » Sat Feb 25, 2006 10:04 am

Cheers mate sorry about being a bit thick but im new to diy ecu s. i have a ford bosch one with a grey two whites and a black do the two whites go to ignition and earth ether way round and the grey sig- and the black+ were do these go does the black go to ignition live and the grey go to the realy board.