MicroSquirt.com read only forum (Jan.15,2018)

is it possible to make MS II output a check light when coolant/air temperature going higher than normal?


Posted by email.

is it possible to make MS II output a check light when coolant/air temperature going higher than normal?

ok ok.. i'm using MS II on my toyota 3TC engine. it has a distributor to do the spark distribution.. now i try to get rid of it and plan to setup a DLI system from MS II


Posted by email.

ok ok.. i'm using MS II on my toyota 3TC engine. it has a distributor to do the spark distribution.. now i try to get rid of it and plan to setup a DLI system from MS II

its very hard to get a toyota GZE or 7MGTE DLI module.. so i'm looking an alternative ways to get my 3TC waste sparked..


Posted by email.

its very hard to get a toyota GZE or 7MGTE DLI module.. so i'm looking an alternative ways to get my 3TC waste sparked..

can MSII control a waste spark DLI without any EDIS module? currently there is only 1 Ignition output from the DB37. i wonder we can configure other additional ports to do the coil packs control?


Posted by email.

can MSII control a waste spark DLI without any EDIS module? currently there is only 1 Ignition output from the DB37. i wonder we can configure other additional ports to do the coil packs control?

seems you are having the same injectors as mine.. you set the injections as low impedence or high impedence(with resistor pack in series with the injectors)?

i experienced the same problem too.. but i can't pressed on the throttle at all. have to crank the engine for at least 6 times without opening the throttle. the engine did started when i cranked it but dies immediately after that. after 5-7 tries, it can started on its own but once u step on the ...