MicroSquirt.com read only forum (Jan.15,2018)

Thanks Lance,

I have a question though...

If I am idling at say 12.8:1 and keep decreasing the PWM criteria, surely the change in idle quality is due to a change in afr? WHat else would change the idle quality.

Because I am injecting a siamese port engine, setting this might not be as easy as the ...

OK guys

I have 2off low impedence injectors and initial settings are 30% and 1.0 ms for the pwm setup.

I tried trimming these values down to find the optimum (1% and 0.1ms at a time spererately as in the manual) and didn't really notice much difference in "idle quality". I got down to 23% and 0 ...

Has anyone got any thoughts on these two questions?

Sorry guys,

Didn't mean to waste your time on that one, my mistake.

I was dropping off on the sofa at the time though.




- Embarassingly slopes off to extract the zipfile...........

Thank you Lance, that's cleared that all up very nicely.

Al, thanks for the note on not setting EDIS. It's running with it set at std coil charging so no problems there. Appreciate you pointing that out though. :)

I have two other related questions I could do with some help on - the subject of one ...

Jim,

I downloaded the txt and it seems to be corrupted. Any ideas?

OK guys,

I’ve got some specific questions related to MS2 and the wheel decoding setup. I did “kind of” ask these on another thread, albeit it was a bit of a hijack of a totally different thread so I thought I’d start another. So, sorry for the semi cross posting, I hope nobody minds as this ...

I agree with you Jim,

There do seem to be many many questions on the same simple subjects repeated over and over again. However, that is the natural way people pursue info in forum based sites. Most forums go to great lengths to drum it into people to use the search button before asking questions ...

All,

What do you think about posting up a few specifics about our setup configurations to try to pick out a few patterns of what works best where? Perhaps something in the format below, keeping general chat to a minimum. A few key comments or observations about other settings that may or may not ...

I am running MS2 V3.0 with a 36-1 VR combo. At the moment it's for fuel only.

I have an occasional stumble at idle and am running 1sr Deriv 2nd Low.

I will have a play with these and report back soon...