MicroSquirt.com read only forum (Jan.15,2018)

Lower the numbers in the bins where you're too rich by 3-4 and see what that does. Also, you are burning any changes you (or autotune) make, correct? The msq and datalog posted would be nice as well....

-Mike

Mike, I will lower the numbers and see where that gets me. I was letting Autotune make ...

Car is 1994 Ford Probe GT(N/A). I am tryin to get my A/F at 13.2 or so at WOT. I am Using MSnS-E, with 024s13 and MT2.25b717. I am pretty sure that I am not in open loop mode. I am using Target AFR with a LC-1 WB and XD-1 Gauge. I have just started using Autotune also. I actually went in and ...

FoundSoul wrote:470 ohm 1/4 watt

Jerry, I installed the XD16 AKA XD-1 and the LC-1 but I did not use the yellow analog wire. I only used the Brown wire with the resistor. Is that ok?

I sent you a PM also.

MSnS-E, MT225b717 V2.2 Main Board..... I think

-Donny

I just purchased the XD-1 with the LC-1. I plan on installing them this week sometime. I have been Running the MS-I V2.2(Fuel Only) for almost a year now. I will be installing the Resistor. Never used a wideband before. I am a little worried I will screw something up.

-Donny