MicroSquirt.com read only forum (Jan.15,2018)

Matt,

Your correct, my mistake. It is reading 20.9 % O2

Free air the unit is reading 20.9:1 in Logworks

Matt,

Did that. This is the machine that I have emailed you about. According to Innovate the product is working correctly. The butane test confirms it, according to them. They also say it is impossible to get a false rich reading

I recently purchased an Innovate LC-1 wideband from DIY. I have it installed and I did all of the calibrations but I am getting a rich reading. The leanest I can get it to read is 11.2:1 but the exhaust pipes are glowing red and the plugs are whiter than new. I have been on the phone with Innovate ...

kemis wrote:Hello!

Did you get the 35 hp vtwin liquid cooled briggs motor to work with microsquirting?
Very interesting in this because I working on a project like this with a air coold Briggs & Stratton Vanguard 35gp engine.

Yes I have three of them converted and working great

Thanks Matt,

I am wanting to use that wire to signal a board to allow the board to read the rpms of the machine and send a signal out to run a servo to control a power valve.

I have a question about the tach output wire that comes from the microsquirt, it is the green/yellow wire. Does anyone know what kind of signal it puts out?

One of my microsquirts has been working great for a couple of months but today one of the machine just died while in use. I noticed that when I went to start it back up the fuel pump was not kicking on. I checked my relay and my grounds, When I turn the Ms on I do not have continuity on the fuel ...

Yes please let me know what I need to do.

Thanks

Grippo,

I just got through converting the 3rd machine. All of three of these are identical units and I have used identical components, wiring layout, etc. The third unit that i just finished, I loaded the msq into and test ran and the unit runs great. The trigger +/- column doesn't move until the ...