MicroSquirt.com read only forum (Jan.15,2018)

Angelos,

The carb spacing it can be managed, but the length of manifolds is the problem. Suppose that is 40-45 mm in order to fit the injectors. That requires a 160-170 mm minimum clearance between the reed cages and the forks and/or wheel.

To much for me. I have to find another solution. Just ...

Angelo,

I am in Athens, Greece.

I worry about the position of the injectors, since they are originally on the head (??).

I have to double check, because the front wheel clearance is limited.

Note that the engine is positioned as close to the swingarm as she can be. I had to remove some ...

Steve,

beautiful job.

you run a megasquirt unit, not a minisquirt (correct me if wrong). Why?

Why only fuel? Isn't possible to run the advance as well?


George

Yes, please.

rg500george@hotmail.com

Where are you located?


George

I have a RZ500 fitted on a TZR250 3XV chassis. Bellow is a pic The project started with an seized and crashed TZR250 3XV, an RZV500 engine in a breaker's yard and a front end from a racer friend.

Initially I was going to fit four carbs (MikuniTM30s), CDI, YPVS controller etc. Despite my efforts ...